Ground noise when switching output

[Karunakaran]

HI

    When am switching any output Ground is bouncing 400mV 3 to 4 rings... is there any guidelines to reduce this

[Ash_R_Intel]

Hi,

Please let us know which FPGA device you are targeting to.

You may refer to documents available:

• AN-731: Simultaneous Switching Noise Guidelines for Intel Cyclone 10 LP, Cyclone IV, and Cyclone III Devices
• Device design guidelines
• AN 75: High-Speed Board Designs
• Pin connection guidelines

Regards.

[Karunakaran]

Targeting to Max 10 10M08SAU169I7G

[ak6dn]

How are you measuring that 400mV noise on your ground? What is the test lead setup into the oscilloscope input?

A less than optimal probing setup can induce false noise into your measurement.

You must be probing 'ground' with respect to 'ground', correct? But where are these two points located?

[Ash_R_Intel]

This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you