Hello Please could you tell me typical current ratings in power rails of Cyclone V E series,ie, 1)VCC 2)VCCIO 3)VCCAUX 4)VCCPD Thanks in Advance.

[EngWei_O_Intel]

Hi Ashad Anil

Sorry for keep you waiting. Can you refer to following document?

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-v/cv_52004.pdf

Let us know if you have question. Thanks

Eng Wei

[AAnil3]

Hi Eng Wei Thanks for the update . But I could not find any electric current rating for individual power rails from my search in the document you shared. Please tell me if you get any update on this. Best regards Ashad Anil

[EngWei_O_Intel]

Hi Ashad Anil

Can you refer to Table10-1 in the document for Maximum Power Supply Current Transient?

You can also refer to power analysis features below:

https://www.intel.com/content/www/us/en/programmable/support/support-resources/operation-and-testing...

Thanks Eng Wei

[AAnil3]

Thanks I have seen this line “You may observe the current transient at VCCPD only when you do not follow the recommended power-up sequence.” So If I’m setting power sequence feature, then can I get rough estimation of currents in power rails? Best Regards Ashad

[EngWei_O_Intel]

Hi Ashad

You can make use the Quartus tools to generate the Early Power Estimator spreadsheet file as mentioned in the doc below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_epe.pdf

Thanks.

Eng Wei

[EngWei_O_Intel]

Hi Ashad

Let me know if you still have any question before we proceed to close the ticket. Thanks,

Eng Wei

[AAnil3]

Hello Eng Wei Thanks for the support. No more queries on this topic. Regards Ashad Anil