- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Plz neone tell me whether it is possible to test the signals using boundary scanning technique without assigning them a pin of programming device.
for eg. if there is a signal connecting two components then is it possible to sense it, as if it is a virtual pin using BSDL. (specifically the internal nodes)Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think that you can get the value of an internal signal through boundary scan. You can use SignalTap to get it through the JTAG connection though.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page