Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

How to register DSP builder 13.1 blockset in MATLAB2012b?

Altera_Forum
Honored Contributor II
‎01-09-2018 06:12 AM
1,087 Views

I have installed both MATLAB2012b and DSP builder13.1 (both compatible), but the standard blockset does not show up in the simulink library. Any help will be much appreciated.

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-10-2018 02:13 AM
218 Views

Hi, 

 

Are you launching MATLAB directly? 

You should use script to launch. 

 

  1. Start MATLAB. 

  2. Run the set-up script by typing the following at the MATLAB prompt: 

 

Check the link 

https://www.altera.com/support/support-resources/intellectual-property/dsp/dsp-builder/ips-dsp-builder-faq.html 

 

Best Regards, 

Anand Raj Shankar 

(This message was posted on behalf of Intel Corporation)
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.