Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
19327 Discussions

How to register DSP builder 13.1 blockset in MATLAB2012b?

Altera_Forum
Honored Contributor II
964 Views

I have installed both MATLAB2012b and DSP builder13.1 (both compatible), but the standard blockset does not show up in the simulink library. Any help will be much appreciated.

0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
95 Views

Hi, 

 

Are you launching MATLAB directly? 

You should use script to launch. 

 

  1. Start MATLAB. 

  2. Run the set-up script by typing the following at the MATLAB prompt: 

 

Check the link 

https://www.altera.com/support/support-resources/intellectual-property/dsp/dsp-builder/ips-dsp-build... 

 

Best Regards, 

Anand Raj Shankar 

(This message was posted on behalf of Intel Corporation)
Reply