- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have been using the JTAG commands: open_device -hardware <hardware> -device <device> for a while. Suddenly it stopped working with the message:
JTAG communication error detected. It can be caused by the hardware failure or signal integrity in the JTAG chain. Try to restart. However, programming the device is okay. It's when open_device is called. Any idea?Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Never mind. I forgot to put my VJI design as the top level.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page