- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I'm trying to port the STAPL byte-code player to and stm32f2xx mcu. but i'm not having much luck. I have connected 4 GPIO pins from the MCU to the JTAG pins on the MAX 10 FPGA, TCK TDI TDO TMS. When i analyze the pins I can see some activity but not much on the TDO pin. And the jbi_execute returns with and exit_code 6 ("Unrecognized device") any good ideas for what I',m doring wrong?- Tags:
- jtag
Link Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am also facing the same problem. I am trying to configure MAX 10 using linux machine through gpio. I also got the same error (Exit code 6: Unrecognized device). Did you got any sollution.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Yes, I got it to work after many hours ;) I will see if I can find the code when I get in the office tommorow, I will give to you to try- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey Nikon,
would you mind sharing your code with us? Thanks!- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
It's been 6 month since i last looked at this code. It was just made as a proof of concept, we decided to go with a solution without an FPGA in the final product. But i have attached the test code that i got running. It's just the source files, it's made with the std_Periph library from ST. Hope it helps- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Wow, thank you so much for the quick reply. Ill see if i can get it to run. Thanks!
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page