How on earth should I use MAX® V CPLD (5M2210ZF256C4N) to configure my Cyclone V GT FPGA (5CGTFD9E5F35C7N), showing that MAX® V CPLD does not allow me to use EPCQ, so how do I use flash
It is possible to configure the FPGA from the EPCQ device. However, the MAX V design provided with the Cyclone V GT FPGA development kit does not allow you to store a design in the EPCQ configuration device.
To enable FPGA configuration using the EPCQ device, reconfigure the MAX V device with the design file, you may refer to the following KDB document:
Good day. I would like to follow up with you on this case. As I haven't heard from you in a while,
this forum thread has been marked as inactive and will be transitioned to community support.
If you have a new question, feel free to open a new thread to get support from Intel experts.
Otherwise, the community users will continue to help you on this thread.
If you feel your support experience was less than a 9 or 10,
please allow me to correct it before closing or please let me know the cause so that I may improve your future support experience.