- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We are using the MAX10, 10M08 in EQFP-144 package. Across boards there are 2 pins that are not working (don't respond to any control, are always low). 1) Pin 52 (of EQFP_144 package) (in Bank 3) 2) Pin 141 (in Bank 8) We have made three boards with these devices and the behavior is consistent across the boards. We checked for shorts (also measured resistance using a MM) and everything seems to be fine. Please advise.Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page