- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had to perform emergency power cut during JTAG programming cycle because other chip started to heat (the cause is wrong output level of unprogrammed CPLD). Now I can not reprogram device any more - programmer gives error almost immediately. JTAG BST is on, security bit it off in PFO file. Will appreciate any advice how to revive the chip. Thank you.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can't help but I am curious as to what you're using to program the chip.. Hardware/Software?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page