- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I recently got a hold of a Cyclone II (part number given in the subject). I installed Quartus II with all board files (including Cyclone II, III, and IV). When making a new project, I see board files for EP2C20F484C7, but not EP2C20F484C7N, so pin assignment does not work. I tried specifically reinstalling Cyclone II board files using the device installer, but Quartus recognized that I already had those files. How can I get the proper board files?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
has been discussed quite often in the forum, just search for keyword "lead free".
There's no functional difference indicated by "N" postfix except for lead-free package, it's the same chip and thus "N" isn't shown in the device selection. Just choose EP2C20F484C7.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you, FvM, for providing a comprehensive answer.
Hello cl7,
You may also refer to this link as your reference:
2) http://web.cecs.pdx.edu/~greenwd/Tutorial-altera-cyclone-board.pdf
Goodluck!
Thanks
Best Regards
Elina
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Do you have any other concern ? If No, shall i close the case ?
Thanks
Elina
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page