- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello there,
I am new here, and I would like to know how I can couple an Signal Generator in some input of the board? How can I do this? And I would like to couple in some output a Oscilloscope, How Can I do that too? The pourpose of my class work is use a Neural Network to detect a harmonic distorcion implemented on FPGA and to do that I need to insert a input signal and in output see the waveform in a oscilloscope. Could you guys help me? Thank you so much. I
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Signals in which frequency range? If you're targeting to low frequency up to audio range, the on-board audio codec might be used for signal acquisition and generation. For high frequency range, an AD/DA daughter card would be needed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In Fact, I want to connect a signal generation ( function generation) on the board, I want want to know how can I do that? The frequency rabge is 60Hz.
Att.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
60 Hz can be well processed by the audio codec (24 bit stereo ADC/DAC with up to 96 kS/s sampling rate). There's some design overhead by accessing the control register through I2C and setting up the serial digital audio interface. You have demonstration projects showing how to.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page