Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20703 Discussions

Post-solder cleaning recommendations for ARRIA-10, Cyclone-V and Cyclone-10 FBGA-s

SSA
Beginner
‎08-25-2020 04:00 AM
408 Views

Hi,
We would like to request reflow soldering and post-solder cleaning recommendations for the following ARRIA-10, Cyclone-V and Cyclone-10 FBGA-s:
10AX048E3F29E2SG
10CX220YF780I5G
5CGXBC4C6F23C7N
Thank you kindly,
Svetlana

0 Kudos

Link Copied

1 Reply
ChiaLing_T_Intel
Employee
‎09-08-2020 08:46 PM
387 Views

Hi Svetlana,

 

Thank you for contacting Intel Community. You can refer to AN353 document which describes the board assembly process used in surface-mount technology (SMT) and focuses on the SMT component-to-board reflow soldering.

https://www.intel.com/content/dam/altera-www/global/en_US/pdfs/literature/an/an353.pdf

In general, the Intel FPGA is not recommended for washing.

 

Thank you

 

Regards,

Chia Ling


0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.