Program the 10M25DA CPLD using command line or batch file. Is there an example? - Intel Community

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Program the 10M25DA CPLD using command line or batch file. Is there an example?

1,676 Views

Currently using the Quartus Prime Programmer Lite Edition to program 10M25DA CPLD. I would like to bypass GUI.

Link Copied

2 Replies

1,240 Views

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/solutions/rd11242004_9502.html

Cheers,

Alex

Copy link

1,240 Views

Hi, You may refer to the link below for more understanding about quartus_pgm (on page 76) https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/manual/tclscriptrefmnl.pdf#page=76 You may also refer to the discussion below for example. https://forums.intel.com/s/question/0D50P00003yyGH4SAM/quartus-ii-programmer-command-line Thanks.

Copy link

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.