Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21153 Discussions

SignalTap -> Data Depth set to 0 -> when useful?

amildm
Valued Contributor I
1,163 Views

Hi All,

 

In SignalTap there is an option to define the Data Depth to '0'... When is this option useful?
 
Thank you!
 
0 Kudos
1 Solution
ShengN_Intel
Employee
1,112 Views

Hi,


When sample depth 0 is selected, no ram is needed. In that case, STP becomes a simple logical condition test tool. The waveform viewer still tells you whether condition is met or not, instead of drawing waveforms.


Best Regards,

Sheng


p/s: If any answer from community or Intel support are helpful, please feel free to mark as solution and give Kudos.


View solution in original post

10 Replies
Vic3Dexe
New Contributor I
1,155 Views

Sample depth? Hmm.. Never paid attention.

Now I'm curios too )

What exactly signaltap shows when sample depth = 0? I can't check it right now myself.

0 Kudos
amildm
Valued Contributor I
1,148 Views
0 Kudos
Vic3Dexe
New Contributor I
1,143 Views

Yes, I get it.

I'm asking what is the actual picture when you press "run analysis"?

Vic3Dexe_2-1655679390763.png

 

 

 

0 Kudos
amildm
Valued Contributor I
1,142 Views

With Data Depth of 0 it seems nothing is captured.... So the question was when the Data Depth is actually useful (if ever)?

0 Kudos
Vic3Dexe
New Contributor I
1,133 Views

As I thought.

IMO this option is useless (0 samples = no data). Just another bug in quartus.

0 Kudos
ShengN_Intel
Employee
1,113 Views

Hi,


When sample depth 0 is selected, no ram is needed. In that case, STP becomes a simple logical condition test tool. The waveform viewer still tells you whether condition is met or not, instead of drawing waveforms.


Best Regards,

Sheng


p/s: If any answer from community or Intel support are helpful, please feel free to mark as solution and give Kudos.


amildm
Valued Contributor I
1,070 Views

OK, so a waveform will not be drawing .... So, how to know that the condition has been met? Should I see some message in the Data Tab instead of waves?

0 Kudos
sstrell
Honored Contributor III
1,064 Views

I've never used it, but I presume the logic analyzer would still trigger and stop running.  You just wouldn't see any data on the Data tab.

0 Kudos
amildm
Valued Contributor I
1,051 Views
0 Kudos
sstrell
Honored Contributor III
1,036 Views

Not sure what you mean.  It seems like this is how it would work based on what Sheng says.

0 Kudos
Reply