Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Altera_Forum
Honored Contributor I
789 Views

The configuration voltage problem in Cyclone IV GX FPGA

According to your documents 'Cyclone IV Device Handbook' Page 175: 

http://www.alteraforum.com/forum/attachment.php?attachmentid=12901&stc=1  

The High logic of the nSTATUS, CONF_DONE, nCONFIG, MSEL[] should be the VCCIO of bank3. 

Meanwhile, according to your documents '150-0311003-B1 6XX-43286R'; it is your model design 'cyclone iv gx fpga development kit board'. In your design schematic file, the bank3 has a 1.8V support voltage, but the nSTATUS, CONF_DONE, nCONFIG, MSEL[] configuration pins in bank3 are linked to a 2.5V high logic. 

So, it that ok for us to have a 1.8V Bank3 support while link the nSTATUS, CONF_DONE, nCONFIG, MSEL[] to 2.5V high voltage?
0 Kudos
0 Replies
Reply