- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am a beginner at using the DE2-115 board. I have completed the "Using Triple-Speed Ethernet on DE2-115 Boards" tutorial but it doesn't seem to work. The .sof file doesn't seem to be generated. Is there any alternate method to make it work or any tips you think may help solve this problem? Any advice would be very helpful. Kind regards, ElvisLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Which version of the tool are you using do you have a license? Check the link below which describes the same issue. https://alteraforum.com/forum/showthread.php?t=39463&page=2 https://alteraforum.com/forum/showthread.php?t=49312 Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm using Quartus Prime Lite 16.1. Would there be any issues using this version? There are no errors displayed to do with the license as I see in the threads you shared. Could there be a similar tutorial or design example for the DE2-115 FPGA board using the Triple Speed Ethernet Megacore and the Ethernet transceivers? Kind regards, Elvis- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Check the below link https://www.altera.com/support/support-resources/design-examples/intellectual-property/embedded/nios-ii/exm-tse-sgdma.html Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page