- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the QUIP design flow, Quartus II will first do technology mapping and then P&R.
If the technology mapping used in the Quartus II is cut-based mapping, when the software decides which one or two LUTs should form an ALM? My guess is, there are two possible ways, one is a extra step after technology mapping and before P&R. The other one is simultaneously processed in the P&R step. Since I didn't found any specific info of that, may anyone tell me about where to find them or share some details? Best Regards, Student Tien-Yu KuoLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page