- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I need to drive an input at a board which is connected to my board through samtec connectors at 200 Mhz, 1.8V, single ended. In cyclone 10 GX device, Which IO standard should I pick?Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is 200 Mhz, 1.8V are maximum rating what connector can withstand? You can use 1.5-V LVCMOS and 1.8-V LVTTL/LVCMOS. Refer cyclone handbook volume 1 (https://www.altera.com/en_us/pdfs/literature/hb/cyc/cyc_c51008.pdf). Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page