Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
The Intel sign-in experience is changing in February to support enhanced security controls. If you sign in, click here for more information.
19700 Discussions

Which IO standard needs to be used? 200 MHz 1.8 V

Altera_Forum
Honored Contributor II
837 Views

Hi,  

 

I need to drive an input at a board which is connected to my board through samtec connectors at 200 Mhz, 1.8V, single ended. In cyclone 10 GX device, Which IO standard should I pick?
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
105 Views

Hi, 

 

Is 200 Mhz, 1.8V are maximum rating what connector can withstand? 

 

You can use 1.5-V LVCMOS and 1.8-V LVTTL/LVCMOS. 

Refer cyclone handbook volume 1 (https://www.altera.com/en_us/pdfs/literature/hb/cyc/cyc_c51008.pdf). 

 

Best Regards, 

Anand Raj Shankar 

(This message was posted on behalf of Intel Corporation
Reply