Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20677 Discussions

Which IO standard needs to be used? 200 MHz 1.8 V

Altera_Forum
Honored Contributor II
‎06-07-2018 01:11 AM
941 Views

Hi,  

 

I need to drive an input at a board which is connected to my board through samtec connectors at 200 Mhz, 1.8V, single ended. In cyclone 10 GX device, Which IO standard should I pick?
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-07-2018 02:13 AM
209 Views

Hi, 

 

Is 200 Mhz, 1.8V are maximum rating what connector can withstand? 

 

You can use 1.5-V LVCMOS and 1.8-V LVTTL/LVCMOS. 

Refer cyclone handbook volume 1 (https://www.altera.com/en_us/pdfs/literature/hb/cyc/cyc_c51008.pdf). 

 

Best Regards, 

Anand Raj Shankar 

(This message was posted on behalf of Intel Corporation
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.