- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Thank you for your reply.
The picture above is the waveform of the nCSO pin during initial startup.
The left is GOOD(EP4CE6F17C8N), but right (EP4CE6F17C8NAD) is NOT GOOD.
all condition is same (SMT, parts, etc)
What do you think is the problem?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know what do you mean by "not good"? Have you monitor the "nStatus" signal with the "nCSO" signal? Have you confirm if the MSEL setting is correct?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page