Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.

XADC output

Sam_chess
Beginner
563 Views
the plot of the sampled data from xadc doesn't match input signal
i used a sine wave as an input to xadc of the nexys4ddr board but when I plotted the 12 bits converted to decimal and then multiplied with 244microvlots for 1 microsecond step time i got a weird signal (it is unipolar mode) please i need help for this and thenks for your time and help
Labels (1)
0 Kudos
4 Replies
KennyTan_Altera
Moderator
526 Views

Is this related to FPGA project?


0 Kudos
Sam_chess
Beginner
513 Views
Yes I use the ADC of the Nexys4ddr FPGA board
0 Kudos
FvM
Honored Contributor II
491 Views

Hi,

Nexys4ddr is a Xilinx Artix 7 board. You are in the wrong forum, check AMD/Xilinx forum. 

0 Kudos
KennyTan_Altera
Moderator
423 Views

Since this is not altera support, we shall close this thread.


0 Kudos
Reply