Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20703 Discussions

arria gx development board output port

Altera_Forum
Honored Contributor II
‎01-13-2010 05:26 AM
996 Views

I'm an FPGA green hand. I wanna use the Arria GX development board to generate 3 singals to control the movement of a probe. I don't know how can I do this, and how can I connect the signals to the target? since I didn't find any output ports on the board. :confused: 

 

Hope I can get some useful help.  

 

Thanks!
0 Kudos

Link Copied

3 Replies
Altera_Forum
Honored Contributor II
‎01-14-2010 01:32 AM
270 Views

You have to use a daughter board of type GPIO-HSMC, like this: http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=67&no=218 

 

Thus you can access the IOs of HSMC connector of Arria Gx kit.
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎01-14-2010 03:03 AM
270 Views

Thank you very much! 

 

Can I connect the AD/DA data conversion card to the arria gx devlopment board?
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎01-15-2010 07:01 PM
270 Views

Yes. It's possible.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.