I am trying to change the FPGA to be installed from 10M50DAF484 to 10M25DAF484.
In that case, L3 should be changed to NC, but is it possible to leave it as GND?
Does L3 of 10M25DAF484 actually have NO bonding wire?
- MAX10 FPGA
In general, you can refer to link below for NC pins:
We do not receive any response from you to the previous question/reply/answer that have been provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.