configuration of Cyclone® II Starter EP2C20 development board (EP2C20F484C7N)

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

configuration of Cyclone® II Starter EP2C20 development board (EP2C20F484C7N)

986 Views

Hello,

Reference to the schematic of the Cyclone® II Starter EP2C20 development board (EP2C20F484C7N),

1- It is shown that it is not possible to use the USB Blaster cable. However, I found that JP3 but it is not assembled on the board. Can this be used with the USB Blaster cable?

If not, how we can use USB Blaster cable with this kit in JTAG mode

2- What is the function of the EEPROM of the part number "93LC46B" which is assembled on the board?

3-Is the SRAM chip assembled on this board used for the FPGA configuration?

4- Is the SRAM chip assembled on the “Cyclone III F780 Development Kit board used for the FPGA configuration?

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.