Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21333 Discussions

getting programming error

Altera_Forum
Honored Contributor II
‎06-30-2011 12:52 AM
943 Views

I entered a very simple design, compiled it, and then tried to program my Stratix II device. 

There are 2 devices in my JTAG chain, the Stratix II (device 1) and a power PC (device 2). 

I set up the JTAG chain, hit start on the programer and then got: 

  • Info: Started Programmer operation at Wed Jun 29 17:26:30 2011 

  • Info: Configuring device index 1 

  • Info: Device 1 contains JTAG ID code 0x020950DD 

  • (then the status bar goes from 0 to 98%) 

  • Error: Can't configure device. Expected JTAG ID code 0x020950DD for device 1, but found JTAG ID code 0x00000000. 

  • Error: Operation failed 

  • Info: Ended Programmer operation at Wed Jun 29 17:26:40 2011 

Any clues as to what I am doing wrong? 

  • (using USB-Blaster & Mode: JTAG) 

  • (Power PC set to Instruction Length 8) 

  • (Auto detect works befor programing but gets "Unable to scan device chain" after error. Need to power cycle to get chain unblocked) 

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.