- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I need some information regarding a design, where if two devices are JTAG daisy chained e.g. Altera CPLD and Atmel SAM4E series microcontroller.
As far as the hardware and layout is concerned, I know how to daisy chain, however I dont know how can I tell the programmer to program Altera CPLD and to IGNORE the SAM4E microcontroller.
Also I prefer to work with make files, is there a way I include that instruction in my Makefile so that when I issue "make program" it ignores SAM4E microcontroller and programs Altera CPLD?
I thank you for your help.
- Tags:
- jtag
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Currently I am reviewing the forum for any open questions and found this thread. I apologize that no one seems to answer this question that you posted. Since it has been a while you posted this question, I'm wondering if you have found the answer? If not, please let me know, I will try to assign/find someone to assist you. Please do expect some delay in response as most of our agents are out of office due to the year-end holidays. Thank you.
Regards,
Nooraini
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page