Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

<terminated>nios Nios II Hardware configuration[ Nios II Hardware] nios II download

RWang54
Beginner
‎03-15-2019 02:13 AM
752 Views

I used Nios II system to try and build a project and download it onto the FPGA board. But when I tried to run the program in Eclipse, the process is terminated at around 64%, and the only message I get in the console is:

"Using cable "USB-Blaster [USB-0]", device 1, instance 0x00

Processor is already paused

Reading System ID at address 0x000000A8: verified

Starting target processor"

What could I be doing wrong?

0 Kudos

Link Copied

1 Reply
Ahmed_H_Intel1
Employee
‎03-25-2019 02:40 AM
322 Views
Hi, Please check the JTAG frequency, this might be the root cause for this. To change the JTAg frequency open the command shill and use the following command: jtagconfig --setparam <cable number> JtagClock <frequency><unit prefix>
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.