Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21148 Discussions

program .jic file successfully but FPGA can't start by it.

dhw333
Beginner
1,538 Views

The .sof file can program and work well,but the .jic file that in JTAG chain shows successful can't work.

This PCB has been cured successfully before and can work normally.The only difference is that the JTAG downloader has been replaced.

The boards with the same hardware are still the same problem. 

 

The FPGA is EP4CEF15I7N. And the FLASH is EPCS16.

0 Kudos
4 Replies
ak6dn
Valued Contributor III
1,526 Views

You need to provide more specific info on your configuration and problem if you want any useful help.

What version of Quartus? What OS?

What do you mean by 'JTAG downloader has been replaced'?

What do you mean by '.jic file shows successful (but) can't work'?

0 Kudos
dhw333
Beginner
1,471 Views

THANKS for your reply.

Quartus 14.1,WINDOWS 10.

Compared to the previous successful download, only the JTAG downloader has been changed.

The process of the Programmer interface shows success. But restarting the power is still the old program.

Take another new PCB board with the same hardware and there will be no program.

 

0 Kudos
NurAiman_M_Intel
Employee
1,426 Views

Hi,


By ' JTAG downloader has been changed' do you mean the USB blaster cable is replace?


Any error shown? What do you mean by 'restarting the power is still the old program.'?


Regards,

Aiman


0 Kudos
NurAiman_M_Intel
Employee
1,313 Views

We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you


0 Kudos
Reply