- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Quartus Prime Pro 19.1 with 19.1.1 patch. There are 3 FPGAs (1SG280HN2xxx) in JTAG chain. I can use .sof to program them properly. Then a JAM file has been generated for JTAG programming. I use quartus_jli command line and try to program FPGAs with generated JAM file. It failed with exactly same error message as version 17.1.1 described in Forum.
I got same error message by using Corelis JTAG tool.
Did 19.1 fix this bug or it is a open ticket?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think our PWA design and Altera FPGAs works fine also. Cause 1: they passed BSCAN without any issue 2: schematic design was verified with Altera engineer 3: FPGAs can be programmed with .sof files using ByteBluster of Quartus prime pro 19.1 .
I am wondering if Quartus prime pro 19.1 still has same software issue as Quartus prime pro 17.1.1 which can't program FPGAs with .jam file.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page