- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had some issues where (2) drives dropped out of my Raid 0 array. I was able to recreate the array by re-adding all drives and all the data appears to be intact, however IRST has been 'verifying' for over 1 month and is only now at 13%. My volume is 12TB. Is this normal for IRST to take this long to verify, perhaps because the volume is large?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello grocerylist,
Thank you for contacting Intel Communities.
In this case, IRST will rebuild the RAID 0 only when the computer is being used, if it goes to sleep or hibernates, the process will stop.
Please let me know how it goes.
Regards,
Juan Carlos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Juan,
My computer doesn't go to sleep or hibernate. The verification is now at 14%. Is this normal for a 12TB Raid 0 to have only verified 14% in a little over a month?
Thanks,
Ray
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Juan,
Haven't heard anything from you since last week. My IRST verify is now at 16% complete. Can you let me know if this is normal for a verify to take this long? It's taken about 5 weeks now to get to 16%.
Thanks,
Ray
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello grocerylist,
Sorry for the delay.
Actually, it shouldn't take that long for it to be completed.
- Are you using HDDs or SSDs? Are they combined in the array?
- Please provide the model number of each drive:
- What is the model number of the processor you have?
At this moment, the process shouldn't be interrupted to start over, we should wait until it is completed.
I hope to hear from you soon.
Regards,
Juan Carlos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Juan,
I'm using HDDs. Yes they're combined in the array.
Model numbers: WDC WD30EFRX-68EUZN0
The processor I have is i5 4670K.
I'm now at 20% complete.
Thanks,
Ray
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi grocerylist,
In this case, since you mentioned that all data appears to be intact, I would recommend backing up all your data and create the RAID 0 from scratch and then transfer the information.
Regards,
Juan Carlos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi grocerylist,
I was reviewing this thread and I wanted to know if you need further assistance.
If so, please don't hesitate in replying to this post.
Regards,
JC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I decided to keep the verification running. I'm at 94% now, hopefully it will finish in the next week or two.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page