Server Products
Data Center Products including boards, integrated systems, Intel® Xeon® Processors, RAID Storage; and Intel® Xeon® Processors
Announcements
Welcome to the Intel Community. If you get an answer you like, please mark it as an Accepted Solution to help others. Thank you!
4299 Discussions

Mother Board S3210SHLC - Connecting Front Panel Wires to where on the 24 Pin Header?

idata
Community Manager
1,209 Views

HI All:

We need some help with signal name terminology for the Front Panel Connector ( Header) on a S3210SHLC Server Board. See the attached Jpeg for a screen shot of the connector on the board. Can anybody convert the signal names listed to more generic descriptions?

Secondly, We are using a server enclosure that has the tradition single wires (2 conductor) coming from the front panel. Each is labeled "Power SW", "Reset", "Power LED", Device 1-6 etc. We want to confirm our logic for connecting each wire.

If you look at Pin 11 on the "24-Pin header PinOut", the name is "FP_SW_ON_HDR_N". Question >> Do we connect our power switch cable (which should be both negative polarity) to pins # 11 & to # 9 to complete the circuit? (Pin 9 is labeled "LED_HD_N")

The same question / Theory applies to the rest. Do we connect our remaining wires to the same physical grouping? eg, 1+3 5+7 13+15 and so on?

Thanks in advance

Michael

0 Kudos
1 Reply
idata
Community Manager
322 Views

Michael - one of the PME's had to do some testing (as we dont use '2 pin desktop implementation). Anyway, hoping this gives you the answer you needed, so try this - and reply back if it doesnt give you what you need - or if you have any further problems.

-

Power Switch = 11 (FP_SW_ON_HDR_N), 13 (GND) Reset = 15 (FP_RST_FPHDR_N), 17 (GND) Power LED = FP_PWR_LED_P1, 1, 5 HDD LED = P3V3 (7) and LED_HD_N (9)

Reply