Server Products
Data Center Products including boards, integrated systems, Intel® Xeon® Processors, RAID Storage; and Intel® Xeon® Processors
Announcements
Welcome to the Intel Community. If you get an answer you like, please mark it as an Accepted Solution to help others. Thank you!
4302 Discussions

My old server SC5300LX+SE7520BD2 won't boot after removing a second PSU

JArau1
Beginner
932 Views

Hello,

I have a intel server SC5300LX+SE7520BD2 with 1+1 redundant PSU (Delta electronics C46098-005). As one of the PSU had a amber led lighting, I decide to check the part-number and I did this by, shutdown the system, remove both the power cord, remove the failed PSU, plug again the power cord on the good PSU and press the power button.

However, for my complete surprise, the server didn't boot.

Then I try to insert the other PSU (the failed one) again but the server still don't boot.

I notice there is no any led lightning on any PSU, so I am not sure could be the problem.

Any suggestions is really welcome. I am stuck on this and I don't know if I should replace the boot PSU or, the mainboard, or even the AC-026A power distribution divider (Delta Eletronics C46103-007)

Thanks

João

0 Kudos
1 Solution
idata
Community Manager
91 Views

Hi,

Based on the issue described, it is very rare that both power supplies failed at the same time so we suggest replacing first the power distribution board. If the issue persists then we can consider the board is defective.

View solution in original post

1 Reply
idata
Community Manager
92 Views

Hi,

Based on the issue described, it is very rare that both power supplies failed at the same time so we suggest replacing first the power distribution board. If the issue persists then we can consider the board is defective.

View solution in original post

Reply