Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Novice
2,057 Views

RMM3 Remote management module

On the S5520UR board, does the RMM3 emulate a USB keyboard, or a PS2 keyboard?

0 Kudos
3 Replies
Highlighted
Employee
10 Views

USB

0 Kudos
Highlighted
Valued Contributor III
10 Views

Does it matter for some reason?

The RMM3 uses a USB interface to connect the RMM vitural Keyboard and Mouse.

If you look in BIOS set-up it reports the Keyboard & Mouse there along with any local keyboards & Mice.

0 Kudos
Novice
10 Views

I wanted to install SCO Openserver 6.0.0 on this system http://www.intel.com/products/server/systems/sr2625ur/sr2625ur-overview.htm http://www.intel.com/products/server/systems/sr2625ur/sr2625ur-overview.htm

The problem was that the installation routine requested input from the keyboard before loading the USB keyboard driver.

I resolved the issue by:

Building a simple desktop system with an IDE controller, 2gb of memory, a standard PS2 keyboard and mouse, and a PCI Express slot.

I installed the LSI RAID controller(LSI00178) in the PCI Express slot along with four 256gb SSD disks and a standard IDE cd-rom, as primary master.

I booted from the SCO boot disk (second cut) and loaded the megasas driver from the SCO maintenance pack 4 device driver cd.

When the installation was complete, I rebooted the system and installed maintenance pack 4, and most importantly installed OSS714 which is a fix for a USB 2.0 problem with systems having more that 4gb of memory, and the network driver package (nd) on the MP4 driver cd.

Finally I installed the RAID controller, and the SSD's into the SR2525UR chassis.

The onboard ethernet chip is not supported, so I substituted an Intel PRO1000MT.

All of the cd's used are available from SCO's web site.