- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm posting this in the hopes that someone can help. I have looked through various sources online, but could find no answer or discussion, so I'll be opening it myself.
I'm not sure what all information I should start with about the server, but I'll start with the following:
Intel(R) Server Board: S5400SF
Intel(R) Server System: SR1560SF
System BIOS: S5400.86B.07.00.0033
BMC Firmware Revision: 0.11
HSC Firmware Revision: 2.09
SDR Revision: SDR Package 11
Problem:
I've been having an issue with the throttling mode. Whenever I boot, I receive a POST error, 85FC, telling me that Closed Loop Thermal Throttling could not be configured.
The most information I could find on this issue is that it may not configure properly if any installed DIMMs do not have functional AMB thermal sensors, but as far as I can tell, mine do.
I am waiting to hear back from the seller I purchased this from, but if it is possible to fix this rather than send it back and wait for a replacement (if they agree on that method), I would much rather do so.
Any help would be appreciated.
Thank you in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We regret to inform you that this board has been discontinued for a while now reason why we do not offer any troubleshooting recommendations to address your issue. Thank you for your understanding.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CLTT can be disabled in BIOS Setup, Advanced > System Acoustic and Performance Configuration. You able to get into BIOS Setup?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am, but I'm trying to get it to stay in CLTT. It always defaults back to OLTT due to the error.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Reading this directly off the memory modules.
4x 1GB 2Rx8 PC2-4200F-444-11
4x 1GB 2Rx8 PC2-5300F-555-11
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All modules are FB-DDR2. SPD shows bandwidth and timing data for all.
Is there anything specific I should post?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Manufacturer and PartNumber fields please. You can attach a screenshot to post.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
We regret to inform you that this board has been discontinued for a while now reason why we do not offer any troubleshooting recommendations to address your issue. Thank you for your understanding.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page