I moved the server 6 inches and now it wont start. Just one long beep and nothing else. no display either.
the diagnostic leds show 0 0 0 X 0 X 0 X
the manual does not cover the led combo above. any thoughts?
Tried unplugging and re-plugging the power cord, removing all power and
connections from M/B, reseating all components, same 1 long beep and nothing else.
Please help
Hi,
Here are our recommendations:
- Clear the CMOS battery by removing it for one minute and power cycle the board.
- Take the board out of the chassis and test it over a non static surface with minimum components installed (processor, memory). You can use pins 11 and 13 to power up the board.
- Test the system without memory installed looking for beep codes. If you get 3 beep codes, test with different memory.
- If possible test the system with a regular ATX power supply.
- If the issue persists after removing memory and the power supply, we recommend contacting our support group via phone to replace the board under warranty.
just a follow up: this is custom built server running windows 2012 r2 and it has been
running for the past 6 months.
Hi,
Here are our recommendations:
- Clear the CMOS battery by removing it for one minute and power cycle the board.
- Take the board out of the chassis and test it over a non static surface with minimum components installed (processor, memory). You can use pins 11 and 13 to power up the board.
- Test the system without memory installed looking for beep codes. If you get 3 beep codes, test with different memory.
- If possible test the system with a regular ATX power supply.
- If the issue persists after removing memory and the power supply, we recommend contacting our support group via phone to replace the board under warranty.
For more complete information about compiler optimizations, see our Optimization Notice.