Software Archive
Read-only legacy content
17061 Discussions

Failed to install Windows 7 driver for RS200

Eric_L_5
Beginner
‎11-05-2016 04:26 AM
228 Views

When I installed Windows 7 driver (intel_rs_dcm_r200_2.1.27.2853)  the first time, RS200 firmware was updated and driver was installed, but when I tried to run Camera Explorer, I got "Not Connected".  I uninstalled driver and tried to reinstall driver but got "Intel RealSense firmware update failed, To install this program at a later time, run Setup Wizard again".

Three RS200 devices (Depth, Left-Right, RGB) showed under "Imaging Devices" in Device Manager without reinstall driver, but I could not run Camera Explorer or SDK samples. 

Thanks in advance for help.

 

 

 

 

 

 

0 Kudos

Link Copied

1 Reply
Gal_A_Intel
Employee
‎11-16-2016 05:06 AM
228 Views

Hi Eric L,

Our DCM is only supported in Windows 10.


Best Regards
Gal A
Intel Corporation

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.