Community
cancel
Showing results for 
Search instead for 
Did you mean: 
rzhu1
Beginner
1,471 Views

How to make Intel SSD DC P3600 to support SGL data pointers in NVM Command Set

My question is a little complicated, it's the drivers code level.

I have a driver which use SGL mode to transfer data. But now the status code of completion queue entry is 0x04 when I use SGL mode.

so, what could I do to make the Intel SSD DC P3600 to support SGL data pointers in NVM Command Set ?

 

The Firmware version of my P3600 is 8DV10131. Could I solve this problem through updating the firmware using Intel SSD DCT2.3.1 ?

Tags (1)
0 Kudos
3 Replies
ASouz7
Honored Contributor II
105 Views

Hannah_zhu,

We are going to check and will get back to you as soon as possible.

ASouz7
Honored Contributor II
105 Views

Hello hannah_zhu,

Thank your for your time. As per this documentation: http://www.intel.com/content/dam/www/public/us/en/documents/product-specifications/ssd-dc-p3600-spec... Intel® Solid State Drive DC P3600 Series - Product Specification page # 23, section 5 - Supported Commands Sets does not mention SGL Data pointers as supported in firmware. We are going to forward your inquiry to our engineers.

rzhu1
Beginner
105 Views

The SGL Data pointer which I mean is one part of a NVM Command Sets, exactly in the Command Dwords 9 to 6 according to the NVMe specification. The engineers will know this much about it.

Thank you a lot.

Reply