cancel
Showing results for 
Search instead for 
Did you mean: 

x25-M failure

idata
Esteemed Contributor III

-Running Dell 630 with Win08 Server R2 and 8GB RAM;

-X25-M with latest firmware is running on modular bay;

-BIOS (latest) set for AHCI (but same behavior occurs on IDE setting);

-Machine boots, x25 is recognized and Intell SSD Toolbox shows everything ok;

-SSD runs fine and after a few minutes x25 disconnects and is not recognized;

-Modular bay is taken out and back in and x25 is recognized again;

-Trying to also run VHDs on x25 and failure makes it impossible;

-Anyone suggestions are appreciated.

1 REPLY 1

MBall5
Contributor

I would like you to change the port that you are using along with the cables of the Solid State Drives (power and information); also if you can run a secure erase to this disk, you can download the bootable tool from the following link: http://cmrr.ucsd.edu http://cmrr.ucsd.edu after this you test the Solid State Drive and cannot see the Solid State Drive, I suggest you to test the Solid State Drive in a different compatible motherboard and see if it works there, if the issue persist, please contact the Solid State Drive support phone number: 916 377 7000 option 6.