5100/5300 AGN Wirelss Profile Creation Question

[idata]

I am trying to create two seperate profiles, one that has a configured for WPA2 and othe ohter is set for WEP. The problem I am having is only one profile shows up and I can use either/or but not both at the same time? is it possible to do this or am I just missing something? Thank You in Advance.

[idata]

You can create several profiles but you can only connect to one profile at a time since you have only one wifi card on yoru notebook.

[idata]

Sorry if I was not clear before in my previous question. If I am roaming and there are different SSID's that I need to connect to and I create different Profile for t hose different SSID's, is there a way that the wireless software will automatically switch between those different profiles?

[idata]

Normally it should connect to the SSID it found. You can try adjust roaming aggressiveness to see if this can be of some help

http://www.intel.com/support/wireless/wlan/sb/CS-025787.htm http://www.intel.com/support/wireless/wlan/sb/CS-025787.htm

[idata]

There are two different protected SSID's that I need to connect to, one which is just WEP and the other is WPA2. When creating a profile, it lets me create as many as I would like; however, it will only let me use one at a time, at least that shows up?

[idata]

Yes, one profile can be connected at a time. Try check if "Auto Connect" is set to automatic, this enable auto connection to the available SSID found if you have the profile created.