Embedded Connectivity
Intel network controllers, Firmware, and drivers support systems
862 Discussions

Software and tools to be used for programming the Ethernet controller WGI210A

Naveen_C
Beginner
573 Views

Hello all,

Naveen_C_0-1714587278787.png

I'm using WGI210A Ethernet controller, which is connected to Kontron CPU module through PCIe.

  • The JTAG connector is mapped to the pins JTAG_TMS, JTAG_CLK, and JTAG_TDI of the Ethernet controller.
  • The flash memory FM25V02A-G (Infineon) is connected to pins NVM_SK, NVM_CS_N, and NVM_SI of the Ethernet controller, which correspond to pins WP_N, CS_N, and HOLD_N of the flash memory.

 

Query is MAC Address is not configured (00:00:00:00:00:00). To configure the MAC address

  • What tool needs to be used to program Flash memory?
  • What file needs to be programmed into the flash?
  • Can it be programmed through JTAG, or does any other physical device need to be connected?
  • What physical hardware to be used to program?
  • In document 513655, there are many files. Which file needs to be used in iNVM?

0 Kudos
2 Replies
Fikri_Intel
Employee
539 Views

Hi Naveen_C,


Thank you for posting in Intel Communities.


Based on the inquiry, we will move to the appropriate team for assistance.



Regards,

Fikri_Intel


0 Kudos
CarlosAM_INTEL
Moderator
468 Views

Hello, @Naveen_C:

Thank you for contacting Intel Embedded Community.

We received your request but we want to address the following consultation to understand your request:

Could you let us know all the information about the third-party CPU module that is related to the WGI210A Ethernet controller implementation?

We are waiting for your reply.

Best regards,

@CarlosAM_INTEL.

0 Kudos
Reply