Ethernet Products
Determine ramifications of Intel® Ethernet products and technologies
4967 Discussions

Intel i226 Updating MAC Address

Michael31
Beginner
625 Views

Hello,

 

I was wondering if it is possible to change the MAC address on the i226 after it has been set?

 

We are able to program the i226 NVM image, but we can only set the MAC address once before it goes into a protected state. We program the NVM image, update the MAC, and then reboot and then we can no longer change the MAC address.

 

Is this intended behaviour? Is there a way to reset the i226 so we can change the MAC?


Thanks,

0 Kudos
3 Replies
Sazirah
Employee
585 Views

Hi Michael31,


Thank you for posting in Intel Ethernet Communities.


Regarding your enquiry, since we may have a limited support on this issue, we will move this thread to our Intel Embedded Communities for the team to assist you. They will connect with you shortly.


Regards,

Sazzy_Intel


0 Kudos
CarlosAM_INTEL
Moderator
554 Views

Hello, @Sazirah:

Thank you for contacting Intel Embedded Community.

It would help if you considered that this consultation is not related to an Intel Embedded platform supported through the channel you mentioned.

Please keep in mind this situation when this forum will be transferred.

Best regards,

@CarlosAM_INTEL.

0 Kudos
code9523
Beginner
110 Views

Can you please help with the instruction how to flash this i226-v?

 

Thanks !

0 Kudos
Reply