FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6390 Discussions

Stratix 10 communicating with Arria V

shaiko
Novice
655 Views

Hello,

 

I need to design a high speed communication interface (around 40 Gb/s across 8 differential lanes) between a Stratix 10 and Arria 5 FPGAs. To limit the design effort, I wanted to use Serial Lite.
However, it seems like the Stratix 10 supports SL3 while the Arria V supports SL2.


Please suggest an alternative that would limit the design effort to a minimum.

 

0 Kudos
1 Solution
ZiYing_Intel
Employee
521 Views

Hi shaiko,

 

You may use SL3 because I found that Stratix 10 and Arria V support SL3. For further information, you may refer link below, Table 1, https://www.intel.com/content/www/us/en/docs/programmable/683330/23-3-20-0-2/quick-reference.html

 

Best regards,

zying


View solution in original post

0 Kudos
6 Replies
ZiYing_Intel
Employee
614 Views

Hi,


May I know you are using which quartus version?


Best regards,

zying


0 Kudos
shaiko
Novice
575 Views

I don't have a design yet.
I can use any Quartus version.

0 Kudos
ZiYing_Intel
Employee
558 Views

Hi shaiko,

 

My suggestion is you can use SL3 if you use the device Arria 10 instead of Arria V. For further information, you may refer link below, Table 1, https://www.intel.com/content/www/us/en/docs/programmable/683330/23-3-20-0-2/quick-reference.html

 

Besides that, as I know, only Arria 10 device has the special request for a special license to enable the Intel Quartus® Prime software to generate the FPGA configuration file (.sof) when using SL2. For further information, you may refer link below, Table 1 SerialLite II IP Core Release Information, https://www.intel.com/content/www/us/en/docs/programmable/683179/16-1-16-1/seriallite-ii-ip-core-overview.html

 

Best regards,

zying


0 Kudos
shaiko
Novice
539 Views

I need to design a high speed communication interface (around 40 Gb/s across 8 differential lanes) between a Stratix 10 and Arria 5.

That's a hard requirement - I can't use Arria 10. It must be Arria 5 and Stratix 10.

What's the easiest way to connect them ?

 

 

0 Kudos
ZiYing_Intel
Employee
522 Views

Hi shaiko,

 

You may use SL3 because I found that Stratix 10 and Arria V support SL3. For further information, you may refer link below, Table 1, https://www.intel.com/content/www/us/en/docs/programmable/683330/23-3-20-0-2/quick-reference.html

 

Best regards,

zying


0 Kudos
ZiYing_Intel
Employee
465 Views

Hi shaiko,

 

Since your issue has been resolved, I am now close the case. If you happen any issue after the case closed, please do feel free to submit another issue.

 

Best regards,

zying


0 Kudos
Reply