FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6479 Discussions

XAUI core simulation for Cyclone V

Altera_Forum
Honored Contributor II
‎10-21-2013 08:41 AM
1,192 Views

Hi, 

I'm simulating in Modelsim XAUI Phi core generated by Megawizard for Cyclone V. I use QII 13.0.1. 

This is a stand-alone simulation (core only) 

The problems: 

 

1. No stimulus in the simulation files, generated by Megawizard, only "bare" XAUI core called for simulation. 

2. When I added stimulus generation module, signal phy_mgmt_waitrequest, set to 1'b0 by reset, set to 1'bZ in every phy_mgmt bus read/write attempt 

3. channel 3 of XAUI output becoming undefined soon after simulation started. 

 

Anybody have the same problems or may be give any suggestions, advices, solutions??? 

 

Thanks.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎12-13-2013 10:58 AM
337 Views

Thanks for all! Problem is solved, solution is here: http://yadi.sk/d/s2kbxtjtefkoc

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.