- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I want to use an Arria 10GX FPGA for OpenCL programming, therefore I connect it to a PCI slot on a host machine. However, before I can do anything else, it is not listed by lspci. What should I do to make the FPGA PCI card to be recognized by the host machine? It should be visible even before doing anything else, right? Thank youLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The PCIe HIP needs to be programmed with a bitfile and then the system needs to be rebooted.
If your Arria 10 card is already setup for OpenCL this would be in flash and would have happened when you powered up.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page