FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5951 Discussions

Help!Stratix II EP2S60 DSP Development Board

Altera_Forum
Honored Contributor II
‎08-10-2007 01:42 PM
1,076 Views

Following the manual, I have downloaded the .hexout file to the flash on the board with the flash programmer of NIOS II, but when I shut down the board and turn on it again, the .hexout file downloaded in the flash doesn't work, the 'error' and 'factory' LED turns on. Is there any additional steps I have not taken? Or, is there any problem with the flash address? The address of flash starts at 0x00000000. And the .hexout file is created from .sof file in Quartus 6.0.Thank you!

0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎04-20-2012 03:20 PM
246 Views

Hello, 

We also have the Stratix II EP2S60 DSP Development Board and we are facing the same problem. Any help is wellcome!
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎04-20-2012 04:26 PM
246 Views

I vaguely recall there are toggle switches on the board that select the configuration source. Did you check they are setup correctly? 

 

Why do you care about the factory configuration? Its really not that exciting. 

 

If you need an example design, just ask. I have the kit. 

 

Cheers, 

Dave
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.