Community
cancel
Showing results for 
Search instead for 
Did you mean: 
dkim37
Beginner
452 Views

How can I use the loan I/O?

Hello I am new to fpga.

I try to use uart for send data to pc.

I use de1-soc and there are two part FPGA and HPS.

According to my understanding, UART is connect with HPS, so I should borrow the pin use loan IO.

In the back, I attached a picture of how I did it.

​First I only use tx, so I activated loan io 62.

loanio활성화.png

and export loan ioloanio핀뽑기.png

and make this code (loan io oe 62 <=1 (out) / loan io out 62 <= uart_txd62번 아웃에 TXD 연결.png

​It is my top level. I have another code for uart탑레벨엔티티.png

Compile is completed but uart is not working.

Please advise for me. what is wrong. and how to use loan I/O

Thanks a lot.

0 Kudos
4 Replies
VROGE2
New Contributor I
164 Views

Did you ever figure this out? I am also trying to use the UART on a cyclone V SoC using LoanIO but I am having some troubles.

dkim37
Beginner
164 Views

We haven't solved your problem yet.

I contacted a local Intel company but did not receive an accurate response.

Please let me know if you can solve it.

We are just buying uart-gpio and using it.

VROGE2
New Contributor I
164 Views

Upon a second look at your code I noticed that you're using LoanIO 62. From some of the other research I have done on this subject I believe that you have to use LoanIO 50 as the TX. I could be completely wrong but it might be something that would be worth a shot. The UART-GPIO may be the way to go for me as well if I can't get mine to work either so let me know how that goes.

TSche18
Beginner
164 Views

Anybody something new? Have the same problem since...I don't know when, but nothing helps

Reply