How to slove Error (209025): Can't recognize silicon ID for device 1.

[totolo]

Hi !

I am using Quartus Prime 18.1 and programming a JIC file to the EPCQ256 on the Altera Cyclone V E FPGA Development Kit. I have already set the MSEL as follows:

• FPGA_MSEL0 ON
• FPGA_MSEL1 OFF
• FPGA_MSEL2 ON
• FPGA_MSEL4 OFF
  I also set 5M2210_JTAG_EN to ON.

Is there anything else I might have missed or need to do?

[NurAiman_M_Intel]

We sincerely apologize for the inconvenience caused by the delay in addressing your Forum queries. Due to an unexpected back-end issue in our system, your Forum cases, along with others, did not get through as intended. As a result, we have a backlog of cases that we are currently working through one by one.

Please be assured that we are doing everything we can to resolve this issue as quickly as possible. However, this process will take some time, and we kindly ask for your patience and understanding during this period. The cases will be attended by AE shortly.

We appreciate your patience and understanding, and we are committed to providing you with the best support possible.

 Thank you for your understanding.

[NurAiman_M_Intel]

Hi,

Can you run the JTAG chain debugger and provide the screenshot here?

Regards,

Aiman

[NurAiman_M_Intel]

We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you