FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6194 Discussions

Intel Max 10 M08 evaluation kit push button (SW1 & SW2) pin map

rohith1
Novice
1,111 Views

I am trying to use pushbutton SW1 and SW2 on the eval kit but I can't find the corresponding pins anywhere in the documentation. I'd appreciate it if anyone could link the corresponding  pin map for the M08 evaluation board. 

0 Kudos
4 Replies
AR_A_Intel
Employee
1,074 Views

Hi

 

Welcome to INTEL forum. May we know, is this the dev.kit that you refer to ?https://www.intel.com/content/www/us/en/programmable/products/boards_and_kits/dev-kits/altera/kit-max-10-evaluation.html

 


0 Kudos
rohith1
Novice
1,068 Views

yes, it is! the pin locations for the dip switches and LEDs are specified but I can't seem to find info on the push buttons.

0 Kudos
AR_A_Intel
Employee
1,057 Views

Hi

 

You can refer to board schematic on corresponding pins for SW1 & SW2. Refer to Table 2. MAX 10 - 10M08 Evaluation Kit Documents Available > Complete kit document installation for schematic.

For more refer to MAX 10 FPGA (10M0S, 144-EQFP) Evaluaion Kit User Guide https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_max10_eval_10m80.pdf


0 Kudos
AR_A_Intel
Employee
1,042 Views

We have not heard from you and I hope that my last note clears up this matter. If you don’t have any further question, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


0 Kudos
Reply